Ortofon LH-6000 Tonearm Headshell Stands 7 msec duty cycle 3:7:

7 msec duty cycle 3:7: When monitoring the output of your cartridge with an oscilloscope you’ll then see a square wave located precisely above each other if the connection from the cartridge is correct

with 30 watts RMS power output (both channels driven into 8 Ohms)-Speaker binding posts will accept bare wire and 4mm banana plugs (once blanking grommets are removed)-Remote control volume (via high quality motorised ALPS potentiometer)

an arrangement that uses their three point D

re-designed and stiffer headshell for improved usability and appearance

Features:-Features a low mass Nude (one Piece) Special Line Contact stylus and Boron cantilever -A neodymium magnet and pure iron yoke provides increased magnetic energy -Threaded inserts in the cartridge body enable the cartridge to be mounted on to the headshell with just two screws – no nuts required -Aluminium body minimizes unwanted vibration for reduced resonance and a superior audio reproduction -Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve the purest signal possible Specifications:-Frequency Response: 20-50

Ortofon LH-6000 Tonearm Headshell Stands 7 msec duty cycle 3:7:The LH 6000 headshell is made from Magnesium, which is used for its low mass and rigidity. The Curved front of the headshell mirrors the shape of the Ortofon Cadenza, Kontrapunkt and Winfield ti cartridge bodies. Technical Specifications: Headshell Weight: 13. 5 g Headshell Dimensions (Length Excl. Connector): 47. 5, Width19. 1 mm Cartridge Mounting Distance (Minimum Maximum Distance From Connector): 36. 6 42. 4 mm