Pallets for materials handling. Quality of new wooden components for flat pallets Ingestion-build-276583 Introduction of revised naming conventions

Introduction of revised naming conventions which better match with those found in ITU-T recommendations G

Manufacturers and suppliers of of terrestrial laser scanners

a) melt volume-flow rate

Note 1 - Use of DD IEC/TS 61934 with specific products may require the application of additional procedures

The slope–area method is most often used to document a flood or remarkably high flow event

Pallets for materials handling. Quality of new wooden components for flat pallets Ingestion-build-276583 Introduction of revised naming conventions1 Scope This International Standard gives guidance on minimum recommended timber quality characteristics. It is applicable to new stringers, stringerboards, blocks, and deckboards used for flat wooden pallet assembly. This International Standard does not address the phytosanitation and safety problems, if any, associated with the use of these components.