Geometrical product specifications (GPS). ISO code system for tolerances on linear sizes - Tables of standard tolerance classes and limit deviations for holes and shafts Ingestion-build-126766 This method applies to PEG

This method applies to PEG concentrations as mass fraction greater than or equal to 0

the control of the whole system

The standard can be used by any organization regardless of its type or size

terms relating only to gas welding

free and fixed connectors for data transmission

Geometrical product specifications (GPS). ISO code system for tolerances on linear sizes - Tables of standard tolerance classes and limit deviations for holes and shafts Ingestion-build-126766 This method applies to PEG1 Scope This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 2861. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI (for holes) and ei (for shafts) (see Figures 1 and 2). NOTE In the tables of limit deviations, the values of the upper limit deviation ES or es are