Belt drives. Grooved pulleys for V-belts (system based on effective width). Geometrical inspection of grooves Ingestion-build-59651 and of an acceptable level

and of an acceptable level of quality that helps to provide good service to consumers

NOTE: It’s possible to apply ISO 19011 to other types of audits as long as special consideration is given to the specific competence needed

BS EN 12094-1 provides you with requirements and test methods that can be followed while manufacturing electrical automatic control and delay devices

Recommendations and guidance on the selection and use of escape route signs

except copper alloy

Belt drives. Grooved pulleys for V-belts (system based on effective width). Geometrical inspection of grooves Ingestion-build-59651 and of an acceptable level1 Scope This International Standard specifies the methods of checking the regularity of the grooves and pulleys for V belts specified in the system based on effective width. The grooved pulleys can be designed for use with classical or narrow V belts. The V belts can be either single or joined units. It is intended to specify the inspection parameters and tolerances of grooved pulleys in future International Standards.