Raise3D Hyper Speed Hot End 0.4mm (Pro3 Series Only) 235x235 you will be temperature limited

you will be temperature limited to 300 °C

The Starter Pack is an add on for your E3D HotEnd to boost the speed of printing with vastly increased melt rates and epic layer adhesion

1 42 Stepper Motor Closed Loop Driver Board with OLED Display

ONLY used for support interface

Virgin PC in fact tends to warp considerably when printed at an insufficient bed temperature (<130 ºC)

Raise3D Hyper Speed Hot End 0.4mm (Pro3 Series Only) 235x235 you will be temperature limitedRaise3D Hyper Speed Hot End 0. 4mm (Pro3 Series Only) High flowrate hot ends designed for the Pro3 Series on Hyper Speed Mode. Note: Please note that for Hyper Speed to function correctly, the Hyper Speed Hot Ends 0. 4mm (Pro3 Series Only), the Hyper Speed Auto Calibrator (Pro3 Series Only), and the Hyper Speed Filaments must be installed on a Pro3 Series printer activated with Hyper Speed Mode. The absence of any of these components may result in